What P0602 means on a Audi
| What P0602 means on Audi | Powertrain Control Module (PCM) failure, Wiring issue |
|---|---|
| Code | P0602 |
| Applies to | Audi |
| Defined bythe second character is "0", which marks a manufacturer code | the manufacturer, not SAE |
| Other meanings of this codeno other manufacturer definition recorded for this number | none recorded |
| Generic definition for this numbersome numbers exist as both a generic and a manufacturer code | Control Module Programming Error |
Notes
- P0602 is defined by the manufacturer, not by SAE. The second character of a code says who wrote the definition: 0 and 2 mean SAE, and the meaning is identical on every vehicle. 1 and 3 mean the manufacturer chose it, and another marque is free to use the same number for something unrelated. No other definition for this number is recorded here, but that is not a guarantee one does not exist.
- The definition names the circuit, not the failed part. P0602 tells you which reading fell outside its window on Audi. The sensor, its wiring, its connector, the ground path, and the condition being correctly reported are all candidates. Replacing the component named in the code before testing the circuit is the most common and most expensive diagnostic mistake.
- Read the freeze frame before clearing it. The module stored engine speed, load, coolant temperature and fuel trims at the moment the code set, and that snapshot is usually more diagnostic than the code text. Clearing the code erases it along with the readiness monitors, and a vehicle with incomplete monitors fails an emissions test even with no light showing.
- Manufacturer codes often need manufacturer tooling. A generic scanner reads the number but frequently cannot read the marque-specific live data or run the actuator tests that confirm the fault. Where a generic tool shows the code and nothing else useful, that is a limitation of the tool rather than a dead end.
What P0602 means on Audi
P0602 on Audi — Powertrain Control Module (PCM) failure, Wiring issue.
The same definition applies on Audi, because those marques share the control module software this code comes from.
Why the marque matters for this code
The second character of a trouble code says who wrote the definition. 0 and 2 mean SAE — the meaning is identical on every vehicle sold since 1996. 1 and 3 mean the manufacturer chose it, and any other manufacturer is free to use the same five characters for something entirely unrelated.
P0602 is one of the second kind. That is why a definition found for a different make reads perfectly plausibly and still sends the diagnosis somewhere it has no business going.
The order that finds the fault
A code names the circuit that reported a problem, not the component that failed. The module measured a voltage, a resistance or a timing that fell outside the window it expected, and everything between the module and the far end of that circuit is a candidate — the connector at each end, the harness between them, the ground path, the component, and the condition the component may be correctly reporting.
Read the freeze frame first. Check the free things — connectors, obvious damage, fluid levels, anything disturbed by recent work. Test the circuit. Replace last.
Nearby sizes
Read more
- A Pending Code Is a Warning You Get Before the Light Comes OnMost people only ever look at stored codes. The pending list is where a fault shows up first, and the permanent list is the one that fails an emissions test.
- P0300 Means the Engine Could Not Blame One CylinderP0301 names a cylinder and points at that cylinder. P0300 names none, and points at something all of them share.
- P0420 Is Measured by Two Sensors, Not by the ConverterThe module never measures the converter. It compares two oxygen sensor traces, and five different faults can make that comparison fail.
- P0171 Means the Module Ran Out of Room to Add FuelP0171 is not a sensor complaining. It is the module reporting that it has added as much fuel as it is allowed to and the mixture is still lean.